PS 21 F Wide belts with paper backing for Stainless steel, Metals, Steel

Applications
Stainless steel
Metals
Steel
Properties
Bonding agent Resin
Grain Zirconia alumina
Coating Close
Backing F-paper

Wide belts PS 21 F with paper backing for stainless steel, metal and steel

The wide belt PS 21 F is a special abrasive specifically designed for extra tough materials. It is made up of a paper-based backing to which zirconia alumina grains have been applied with a close coating using synthetic resin. The combination of stable backing and self-sharpening grit turns the abrasive belt PS 21 F into a long-lasting abrasive that delivers an outstanding service life. It used primarily for grinding on:

  • steel and 
    - stainless steel

Zirconia alumina as abrasive grain – Effect

Zirconia alumina is a special abrasive. Its abrasive grains are hard and particularly tough. The grit is composed of crystalline structures that form wedge-shaped grains. After becoming blunt from grinding, portions of the sharp-edged crystals, which make up the grains, will break out of the structure, leaving behind new, sharp edges. The result is a self-sharpening effect. This effect ensures that the abrasive will retain its abrasive performance almost completely throughout its entire lifetime.

Applications of the wide belt PS 21 F

The wide belt PS 21 F is designed for applications during which the workpieces are deburred or rounded. This abrasive belt is available in a large selection of grit sizes ranging from extra coarse to fine.

Connection of the belt joint

The wide belt PS 21 F is an endless belt. There are several ways to glue the joint together. The different joints are designed specifically for each application purpose.

  • Form 1: The abrasive belt joint is cut at a defined angle and joined with an overlap.
  • Form 2: Just as with form 1, the abrasive belt joint is cut with a bevel and joined with an overlap. The grain points at the butt joint are ground down. This ensures that the belt will run even more smoothly.
  • Form 3 G: Here, the butt joint is cut with a zigzag edge and supported with a fabric-reinforced film bonded underneath. This form allows for completely impact-free work on parts that are particularly sensitive to breakage.
  • Form 4 G: Bevel-cut butt joint supported with a fabric-reinforced film bonded underneath.
available on request
Dealer search
Do you want to buy offline or receive advice before you buy? Our dealer search function will show you your nearest Klingspor dealer.